BEL-ADT: Analog and Digital Trainer

DC power supply
Fixed DC output : ±5V, ±12V@500 mA
Variable DC output : Dual, 0~30V, 0 ~ -30V@500mA

AC power supply : 5 ~ 0 ~ 5 VAC, 12 ~ 0 ~12 VAC

Potentiometers : 1KΩ, 10KΩ

Function generator

Frequency Range :
1Hz ~ 10Hz
10Hz ~ 100Hz
100Hz ~ 1KHz
1 KHz ~ 10 KHz
10 KHz ~ 100 KHz

Amplitude

Sine wave output : 0 ~ 6Vpp variable@1Hz ~1MHz in  step of 5

Triangle wave output : 0 ~ 6 Vpp variable @ 1Hz ~ 300KHz in step of 5

Square wave output : 0 ~ 5 Vpp variable @ 1Hz ~ 400KHz in step of 5

TTL mode output : 5 V @ 1Hz ~ 1MHz in step of 5

ADA operates on DC power supply (+12V,-12V,+5V and GND).

Two digits of 7 segment LED display
Two pulse switch

Push buttons to generate inverting and non inverting pulses  supported with de-bounce elimination

Data switches

Toggle switches and corresponding output point. When  switch is set at “Down” position, the output is LO level, contrarily  it is to be 'High' level while setting at “Up” position

Speaker

8 Ω / 0.5W to be used for load

Four channel adaptor

The two banana sockets and BNC jacks suitable for the trainer  to be connected with peripheralsThe two banana sockets and BNC jacks suitable for the trainer  to be connected with peripherals

Sixteen bits LED display

The two banana sockets and BNC jacks suitable for the trainer  to be connected with peripheralsThe two banana sockets and BNC jacks suitable for the trainer  to be connected with peripherals

Red LEDs separate input terminals. The LED will be lighted up when input is at “High level” and it will be turned OFF when it is at “No Input” or at “Low level"

ZIF sockets

40 pin, 28 pin, 20 pin